Overview of the state of water and sanitation in the school
A very important project carried out in built school is equipping it with a functioning network plumbing. Responsibility for the good execution of the plan created previously borne by the administration building, and then selected by the administrative authorities, the director of the school. It should also ensure that the school building was carried out a review of the state of water and sanitation, especially during the holiday season and, if necessary, during the school year. Performance of plumbing repairs in the school can deal with an emergency plumber or hydraulic depending on the type of failure. Therefore, to carry out such repairs may involve the need to close only one of the toilets or the entire school building.
Repair hydraulic hospital
Building a hospital is this type of building, which must run smoothly at all levels. Therefore, in addition to cleanliness in the bathrooms, also asks a lot of attention on the general state of water supply and sewerage hospital. This can prevent the occurrence of various unforeseen situations that could harm the good functioning of the hospital and the safety of his patients. Every few years should, therefore, check the status of the hospital water supply, sewerage and if necessary exchange the already clogged pipes that belong to the network. All of these activities can be carried out by a team of plumbers working in a nearby factory water and sanitation. From time to time you should also be exchanged sanitation in the hospital.
Union - type of piping fitting
A union is similar to a coupling, except it is designed to allow quick and convenient disconnection of pipes for maintenance or fixture replacement. While a coupling would require either solvent welding, soldering or being able to rotate with all the pipes adjacent as with a threaded coupling, a union provides a simple transition, allowing easy connection or disconnection at any future time. A standard union pipe is made in three parts consisting of a nut, a female end, and a male end. When the female and male ends are joined, the nut then provides the necessary pressure to seal the joint. Since the mating ends of the union are interchangeable, changing of a valve or other device can be achieved with a minimum loss of time. Pipe unions are essentially a type of flange connector, as discussed further below.
In addition to standard, simple unions, other types of union exist:
Dielectric unions are unions with dielectric insulation, used to separate dissimilar metals (such as copper and galvanized steel) to avoid the damaging effects of galvanic corrosion. When two dissimilar metals are in contact with an electrically conductive solution (even tap water is conductive), they will form a battery and generate a voltage by electrolysis. When the two metals are in direct contact with each other, the electric current from one metal to the other will cause a movement of ions from one to the other, dissolving one metal and depositing it on the other. A dielectric union breaks the electric current path with a plastic liner between two halves of the union, thus limiting galvanic corrosion.
Rotary unions are unions that allow for rotation of one of the united parts.
Źródło: https://en.wikipedia.org/wiki/Piping_and_plumbing_fitting